Hello alyss,

It took me a while to figure it out too.

You need to type in the following command line with at the end after the last quotation. Remove the (your photo url here) part and just place your photo url between the quotations.

img src="(your photo url here)"

Find a photo sharing site, like allyoucanupload.com. I use that one, so I will explain that format.

The front page has a section for uploading your photos with a browse command to find and add you photos in. Do so and click upload. Wait a few minutes and a new page will come up with 8 url sections for thumbnails and orginal picture selections. Look under the original picture section and you will see one url that states "for forum or message board primary". Copy and paste that url between the quotation marks in the command line and delete the first half and the last part as follows:

Before deletion,

[URL=http://allyoucanupload.webshots.com/v/2001801602700548608][IMG]http://aycu13.webshots.com/image/15132/2001801602700548608_rs.jpg[/IMG][/URL]

After deletion,

http://aycu13.webshots.com/image/15132/2001801602700548608_rs.jpg

What is left is what is the useful part of the url. If you do not delete those sections, the command line will not know what to do with the extra parts and will not post your picture.

The end result should look like this:

{{gwi:549664}}

If you right click the photo and click on properties, you can see the url link address as well as the size of the photo and so forth. Remember to place the greater than less than signs before and after the entire command or it won't work.

This forum uses an HTML Tag and my Photobucket account has a link for that.

You can also copy and paste the link to your picture in the optional link box below the message box and then we would just click on the link to see it.

TEST on posting Pics !!!!!

Here is a link that might be useful: {{gwi:550707}}

heres go's nothing

Here is a link that might be useful: {{gwi:550708}}