Here is my problem�.A few days ago, I noticed one of my impatiens was limp and distressed. The others planted next to it were both fine so I decided to put cuttings from the upset plant in water in an effort to save it. All was well, the clippings perked a few hours after being cut. The next day however, some were limp. This morning I noticed even more were limp. They are sitting in a indoor greenhouse with filtered light from a large window.

Any advice on what is going on? This is my first time propagating impatiens. I am accustomed to placing plants in water and after a few days or weeks depending on the plant type, they root and thrive. Once roots are established, I move them to dirt and viola I have a new plant. Having some issues now.. please help. Thanks.

First you must make sure everything you use is very clean. In a clean pail mix your soil with the water so you make sure the soil is damp right through. Use a soilless mix that is free draining. You want the soil wet but not too wet. Squeeze a handful and some moisture should come out but not a lot. Fill your pots and make a little hole in the center with your finger or something else that will make a small hole so you don't knock off the hormone. Using a small pot it is easier to control the moisture level.

With a sharp knife or razor blade cut a 3 or 4 inch piece from the growing tip, cutting just below a leaf. All roots and branches come from a leaf joint. Remove all but the top 3 to 5 leaves. Dip about 1/2 inch of the cut end in rooting hormone. It comes in powder or gel, either is OK as long as it's for soft wood cuttings. I use Stim-root NO. 1. After it's dipped put it in the hole and cover it in, and you're done.

Keep the soil moist but not overly wet. They will look wilted at first but that will change as it starts to grow roots. You will know it's rooted when it starts to show new growth. Wait until it is rooted well before you set it out.

I hope you can find a healthy shoot.