Very nice set up.

Your system looks good however it is top heavy. you will have to widen your base to create stability or bolt it to the floor. Also it's not clear from your pic if you'll attach your lights from over top which I think would be better than attaching them to the sides when it comes to adjusting the height of your lights. You may also find it awkward having to lift your plants in and out of the white frame part to prune or generally tend to them.
Hope this is helpful

Yes, I probably should widen the base, although right now it is standing just fine. I Would use chains on top of the hood to adjust the lights height.

I just finished building my grow light. I built the needed fixture and connected the wires. For light I am planning to use Philips Super 80 tubes. On the Philips Lighting webpage there is also give a datasheet, which contains wavelength diagram. Perhaps someone could give me some advice, what sort of tubes to use. In my opinion the 840 should be the best. Anyway the datasheet can be seen on this page: http://www.lighting.philips.com/in_en/architect/lamps_leds_gear_innovations/brochures/datasheets/fluo.php?main=gb_en&parent=gb_en&id=in_en_brochures&lang=en
From there choose MASTER TL-D Super 80

P.S. I shall soon also post some pictures of my grow system.

Hi.
I just finished building my grow light fixture. Here are also some pictures. I really must say that I am not a good builder :)
If you have any questions, don't hesitate to ask. You my also tell me what you think of my system and what should I change.

{{gwi:1020595}}
{{gwi:1020596}}

{{gwi:1020597}}
{{gwi:1020598}}

{{gwi:1020599}}
{{gwi:1020600}}