Return to the Plant Propagation Forum | Post a Follow-Up

 o
Looking for Crape Myrtle Rooted Cuttings

Posted by immobilus AZ (My Page) on
Sat, Nov 17, 12 at 14:51

I've been trying for a year now to root cuttings from my young crape myrtle with zero success. I was wondering if anyone has some rooted cuttings (preferably dormant) they would be willing to send me I would appreciate it...

Any color will do but looking for larger breeds.


Follow-Up Postings:

 o
RE: Looking for Crape Myrtle Rooted Cuttings

have you been trying the rooting on any scientific basis.. or just winging it??? .. in other words.. have you researched it..

0% success.. surprises me ..

ken

Here is a link that might be useful: they say its easy ....


 o
RE: Looking for Crape Myrtle Rooted Cuttings

I've followed every instruction I've found online, from propagating indoors in a bag (leaves fall off and stem dies), outdoors in a pot of vermiculite, directly in the ground, etc. even tried root division, but the roots never produced suckers once separated from mother plant. I've tried softwood, hardwood, everything. Nothing.

I have three hardwood stems (pencil thick) in vermiculite now. Been in there a month. No growth. Scratch of the exposed wood shows slight green under bark, no root growth.

I've tried with powdered hormone and no hormone. Soil, sand, and vermiculite. I've tried adding b1 root starter a month into the process, no results.


 o
RE: Looking for Crape Myrtle Rooted Cuttings

Immobilus,

I don't know what zone you're in. I am in zone 7a/7b. I root my crape myrtles in coarse construction grade sand from tip cuttings in warm weather (late spring through early fall). I mist the leaves frequently and they are usually well-rooted within 3-4 weeks. Softwood seem to do better for me. For crape myrtles I strip the bottom 3/4ths of the leaves. If the sand starts to dry out I water it as well. The coarse sand allows water to drain and the cutting is less-likely to rot, however you have to make sure to water the sand itself occassionally and don't let it dry out, it should be moist. Mostly you focus on keeping the leaves misted, that's how you keep them happy until roots can form. The moist medium is mainly so the cutting stays upright. Some successful cuttings will still lose all their leaves only to sprout new ones if a root system was able to develop.

I've never tried the bag method or sticking cuttings straight into the ground unless something already has a small root attached. As for vermiculite, whenever I used to work with it I found it compressed too much and retains way too much water which again is more likely to promote rotting of the cutting. Maybe some folks have had success with it but I haven't. That was the first method I tried when I got into cutting propagation years ago. I found it to be unreliable and costly when compared to sand or some other more coarse media. Some people also use Perlite. Now if you mixed the vermiculite with something that has larger particles it might work better

With crape myrtles, I have probably an average of 85 - 90% success with the sand and misting method. Depending on the time of the year and conditions sometimes I'll have 100% success with some batches. But if you do try the sand it should be coarse builder's sand to properly drain, not that really fine stuff you buy in bags at the store.

Good luck, all I can say is keep trying.
Danielle


 o
RE: Looking for Crape Myrtle Rooted Cuttings

You'll be happy to know I finally got some to root. They were hardwood cuttings, about pencil thick. They haven't grown any leaves yet but I pulled them up and they have about inch-long white, thick, strong roots. Since the hardwood was leafless and couldn't feed itself and with no root action, I took a teaspoon of cane sugar and a b-complex pip and blended it in water. I then added about a teaspoon to each cutting.

Three weeks later, most rooted (after two months of them sitting without roots. One is somewhat rotten, so I pulled it out, cut deep into the pulp with a knife found the layer with the slightest hint of green, and placed it back in. They're in mycorrhizae enhanced growing medium indoors. In about a week I'm going to put a light application of osmocote.

One, the pink valour, was just a 1/8 of an inch twig. I've pulled it up and it hasn't rooted, but there is now a shoot coming up. I wanted to see if the shoot (very fragile) rooted so tugged on it and it broke from the root. Nothing but green still attached. I thought I killed it but replanted it in the pot and its still growing and recently got its third set of leaves.


 o
RE: Looking for Crape Myrtle Rooted Cuttings

Yea!!!!!


 o
RE: Looking for Crape Myrtle Rooted Cuttings

Crape Myrtle root cuttings are easy to grow. I have had great success with them in the pass. Suggestion, don't over water and plant the cuttings in the beginning of spring and leave them alone. I have just stuck them in the ground about two to three inches deep and after four to five weeks, new growth can be seen. My cuttings are pencil thick and approx. six to eight inches high.

Good luck


 o
RE: Looking for Crape Myrtle Rooted Cuttings

Yea, I kept getting told that semi-hardwoods or green wood (new growth tips) were easiest. I could not get a single one to grow. I tried bags, they'd mold. I'd try without bags, they'd wilt. I finally said screw it and took hardwood cuttings, some pencil then and some just lateral twigs that grew prior to first frost. I just stuck them in "GroMix" growing medium, which is made of perlite, peat moss, and mycorrhizae fungus. Took upwards of two months, and the hardwood cuttings themselves are not leading out. Instead, they're sending shoots from the cutting which is mostly beneath the soil. I don't even see that much in the way of roots, either. I think the hardwood has essentially become the root. I just transplanted then to a potting soil with fertilizer.

Anyway one know how long a red dynamite crape myrtle should take from being a shoot on a hardwood cutting to be a semi-woody tree/bush that can brave the elements outdoors? Six months? A year?

I'm anxious to see these babies grow!


 o
RE: Looking for Crape Myrtle Rooted Cuttings

I absolutely don't know for sure, so don't quote me, but my neighbor lady gave me a baby Crape Myrtle that she rooted from her own plant. She said it had been in the pot for "6 months to a year" and was "ready to go outside."
I hadn't been expecting this new plant, so I had no spot in mind for it. I just left it in the 6" pot it came in and parked it on the side of the house until I could find a place. 6 months later, it had gone from 4" tall to 3' tall!
That was last Spring. The same "baby" is now in the ground and is about 6' tall.


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Plant Propagation Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here